1 / 5
Outlet Housing for Leviton 50 amp 250V Recepticle — image 1
1 / 5

Outlet Housing for Leviton 50 amp 250V Recepticle

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a drag friendly remix of my original housing. Instead of a clamp with two screws performing strain relief,…

Rating
0 / 5
Likes
2
Downloads
15
Makes
0
Views
127
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial — Share Alike

This is a drag friendly remix of my original housing. Instead of a clamp with two screws performing strain relief, this one has no separate clamp, nor does it require the two additional screws and nuts. Strain relief is now intended to be a nylon wire tie on the inside of the housing. Pull the cable through, strip enough of the cables outer jacket so the three wires will reach the outlet, then strip the individual wires and connect them to the outlet. Put a nylon wire tie around the cables insulation and tighten it while ensuring there's enough room to fit the connected wiring and outlet into the housing when the cable is pulled back until the wire tie bottoms against the housing. Secure the outlet to the housing with the three screws that held it to the original mounting plate.

This redesign should be less likely to break, having no clamp ears protruding, as the cable is dragged across a concrete floor.

Category: DIY

Tags