1 / 3
Little pit stop - Ford Mustang - Overhang Test
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix with tests to enhance body/chassis overhang, enabling efficient printer fine-tuning.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 22
- Makes
- 0
- Views
- 670
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I had some overhang artifacts when I printed the Ford Mustang.
I used these overhang tests to fix the issue on my printer – maybe you will find them useful – before you attempt to print the chassis.
Tips to improve overhang:
- Print the body/chassis on its side, aligning the roof parallel to the extruder fan.
- Maintain the temperature as low as possible for the filament you are using.
Typically, 200ºC is suitable for Prusament PLA. - Use 0.15mm layer height on a 0.4 nozzle
Best improvement
Best improvement so far is to use a dual fan setup:
https://www.printables.com/model/573330-prusa-mk3s-dual-fan-mountduct