Dehydrator Spool Extension for Hamilton Beach or Westside GameKeeper. No supports.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Extension for Hamilton Beach Dehydrator 32100A or similar. 258x330mm tray fits most 1kg spools and large food items.
- Rating
- 4.6 / 5
- Likes
- 28
- Downloads
- 162
- Makes
- 4
- Views
- 826
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
Extension for Hamilton Beach Dehydrator Model 32100A or the Westside GameKeeper model mentioned in the Makes. 258x330mm tray fits most 1kg filament spool as well as larger food items, mushrooms, and flowers.
No supports needed! Print upside down on the skinny edge. I used a 2mm skirt.
Don't print with PLA, which could become brittle or soft after extensive exposure to higher dehydrator temps. Ideally use ASA or ABS, but PETG at a minimum for temp resistance. I used ABS.
If you have a large capacity print bed, print the full size tray (258x330mm) as a single piece. for "standard" beds, print 2 each of the “right” and “left” corners. You can either glue the tray together, or optionally use 6x3mm disc magnets for alignment and storage disassembly. Make sure to test fit before gluing and pay attention to magnet polarity.
Fusion 360 (.f3d) file is also included for remixing. CC Attribution License.