Drain Grille shower floor waste DWV DN50
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
DWV DN50 Waste Pipe grill, floor waste or sink waste drain grille.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 18
- Makes
- 0
- Views
- 163
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution
I made a floor waste grate for my bathroom/shower. I didn't want a large recessed panel for the grille, and as I polished the floor by hand there wasn't a good way to have a inset plate that was level with the surrounding floor.
Photos are taken after 6 months of use, printed in yellow PETG @ 100% infill
I painted a little bit of PVC glue on the inside of the pipe at the depth that the retaining/support ring would sit at, and then slid the retaining ring into place while clipped into the grille part. I put a little bit of wire threaded through the grille, and taped that to the floor to stop it falling deeper into the pipe before the glue set.
I sanded the top slightly once installed because my floor is not quite level at the drain
It's removable for cleaning (although I haven't cleaned it for 4 months), doesn't seem to get blocked up much, and I have stood on it every shower since installation with no sign of it breaking. I printed a few variations before I got the perfect fit, so I imagine you can just rescale it in the slicer if you find it's too loose etc. There is some variation possible in the modelling software, but I haven't gone to much effort to make it saleable with the hexagonal grid and chamfers etc.
I'll print a DW40 version for my sink and possibly update here if I remember.