1 / 5
Wedge for IKEA SAMLA box tray
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This wedge stops the IKEA tray insert from buckling under the weight of items placed in it, and subsequently falling…
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 36
- Makes
- 0
- Views
- 750
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This wedge stops the IKEA tray insert from buckling under the weight of items placed in it, and subsequently falling off the "ledge" down into the box below.
💪🏼 Features
- Doesn't need a zip-tie → just drill a single 16mm hole
- Slight filet to match exact contour of tray plastic
⚙️ How to use
- Print out the MAIN model
- Position in the tray, and mark 1mm below center of circle with a sharpie. You'll want it slightly lower than exact center, so that it is a snug fit.
- Drill out a hole using a 16mm circular bit.
- If you mess up the hole (too high) print one of the offset models, either 1mm or 2mm.
💡Inspiration:
- Thingiverse – IKEA Samla Insert Wedge → good idea, but requires double-sided tape.
- Thingiverse – IKEA Samla Tray Insert Wedge NG → better, but still requires zip-ties to fasten.