1 / 2
WeatherFlow WEATHERmeter Wind Vane
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wind vane attachment for WeatherFlow's WEATHERmeter.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 514
- Makes
- 0
- Views
- 2,293
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
Wind vane attachment for WeatherFlow's WEATHERmeter.
A single 608 bearing (22mm x 8mm x 7mm) required for assembly. Base has standard ¼-20 threading for tripod mount.
There are two base models, one where the top peg (that goes into the bearing) has a diameter of 8.0mm and the other with a diameter of 8.1mm.
There are three variations of the wind vane:
- Printed counterweight - model must be printed at 100% infill to put the center of gravity directly above the rotation point for proper balance.
- Manual counterweight - can be used as-is, or manually balanced by gluing weights (eg. 7 M6 nuts) to the front end.
- No counterweight - should only be used with high quality bearing with little to no slop.