1 / 9
Mouth Chip Clip from 3D Scan of Teeth — image 1
1 / 9

Mouth Chip Clip from 3D Scan of Teeth

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This chip clip design uses an actual 3D scan of a set of teeth for the jaws.

Rating
0 / 5
Likes
80
Downloads
565
Makes
0
Views
2,385
Reviews
0

Updated at source:

Model information

Category
Kitchen
License
Creative Commons — Attribution — Noncommercial — Share Alike

This chip clip design uses an actual 3D scan of a set of teeth for the jaws. The clip assembly is 100% 3D printed, the spring clip needs to be printed twice (1 for each side). The spring clips slide into the grooves on the jaw and roof, slide them unit the groove on the spring engages with the retention hump inside the groove (there will be a click).The clips will need to be opened slightly to get them in place. I measured about 1 kg of clamping force, however, the force will ultimately depend on the material used for the springs.

Each STL is a single body. Reorient the parts in the slicer so that the large flat surfaces are against the bed - teeth pointing up. Print the springs on the side. The multicolor print was made in PrusaSlicer 2.6.0 using the new "multlimaterial paint" feature. The PrusaSlicer 3mf file is included with the teeth painted to make that step easier.

I recommend printing the springs with PETG because PLA will lose its springiness over time since it is under constant load.

I also included an Step file of clip assembly without the teeth for easier remixing.

Print Settings

Printer Brand:

Creality

Printer:

CR-10

Rafts:

Doesn't Matter

Supports:

No

Resolution:

0.2

Infill:

10%

Filament: 3D Solutech PLA Skin


Notes:

Reorient the parts in the slicer so that the large flat surfaces are against the bed - teeth pointing up. Print the springs on the side.

Print the spring clips with PETG so that they maintain springiness. PLA will stretch over time.

Multicolor effect can be done using the "multimaterial paint" feature in PrusaSlicer 2.6.0. PrusaSlicer 2.6.0 with P2PP was used to slice the model. Mosaic Palette 2 was used for the multicolor print.

Category: Kitchen & Dining

Tags