Gecko Egg holder

Discontinued I wanted something to keep my eggs a bit more stable as my incubator is slid around a lot, and often leads to eggs flipping. Also, since I'm cheap and didn't like the round ones available for $5.

This fits much better than plain old perlite. It's made so that it can be buried for extra egg security. There's also a slot for paper, so that eggs have a bit more detailed labeling, though I intend to use QR codes instead of writing.

I'm also working on a puzzle locking version and a vertical version so I can rig a bunch together in my incubator.

I'm still learning to model, so there's a lot to improve, so thank for looking!

Edit: The last image is a gecko that hatched while on this tray.

Also, there is a newer 8 egg version that I have made here:
https://www.printables.com/model/520481-gecko-egg-incubation-tray

Print Settings

Printer:

Artillery X1 V4

Rafts: 

No

Supports:

Doesn't Matter

Resolution: 

0.2

Infill:

20%

Filament:

YSF PLA 

Black

Notes:

I printed at 0.2mm and 20% infill on an Artillery X1 with PLA. Can be printed with or without support if orienting the egg side up, though it's easier without support.

I have my size settings set so that it came out at 139.7mm X 54.23mm X 10.16mm (5.5 x 2.1 x 0.4 inches)

Can be scaled up or down, but I find that this size is good for nearly ready to hatch crested geckos, and likely for leopard gecko eggs too.

Category: Pets