Music Instrument Phone Lyre

After a long search, no such solution could be bought or found anywhere nearby - a simple, but robust, solution to transform my ordinary lyre into a 'smarthpone' version. So decided to design, mix and match anything myself. And here is the result!!

This is just a simple phone holder hold together by a simple rubber-band, making it a easy to make and easy to maintain solution. trimmed-down and paired together makes it a strong solution. In the middle there is space to fit your original lyre (see the pictures) with on the backside an allowance of 3mm. Ofcourse this can be remixed or I can upload with different sizes, if desired.

Plans are also to trim it down more, but it already is in a good state, sturdy, and just working!

Print Settings

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

20% gyroid

Notes:

To print, I would advise the following:

Main part:

• use 3 wall layers As the lyre will put some pressure on the plastic this might be important. 2 should do it, too, but better safe than sorry.

• infill, the more you use the heavier it will be on the instrument. this is to personal preference. My best bet would be 15/19% gyroid as a good mix between sturdyness and weight.

• support, create a support for the middle part as the bridge would be too much.

Extension part:

• you will need two of those per lyre.

• print with easier settings, leighter settings, as it only needs to hold down your phone into the lyre.

• added a 'connected' version, to make it easier to slide in and out your phone.

Post-Printing

Post-printing, just slide the extensions into the main part and use some rubber bands into the intended slots. I would advise using two per side, if one band breaks your phone will not be flying to the floor :)

Category: Music