Skadis Cup Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two piece, light but strong cupholder
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 217
- Makes
- 4
- Views
- 854
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
This is a lightweight but strong cupholder bracket for the Skadis pegboard. It is printed in two parts so that the parts can be orientated on the bed for strength.
I designed these with a narrow, vertical profile so that as many cups can be attached to a single board as possible - in the config shown, 30 cups fit on the one board. The rings have a slight taper and only fit the bracket one way - wider part of the ring should face up and the bracket pushed in from the bottom.
I printed .28 layers, with each holder taking about 30mins. The two parts press together well, but you may need to clear any elephants foot to ensure they seat together fully. They are a firm fit, but a drop of CA glue is a good idea depending on the application.