Pavo Pico Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Protective case for Pavo Pico FPV drone
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 56
- Makes
- 0
- Views
- 916
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Assembly:
The case has two parts attached using the hinge. I used a small metal rod cut to the total length of the hinges on the back but small nails around 1mm in diameter or similar could be used and glued into place(Make sure to glue to the top OR bottom and not both). The Updated version is also held closed by 6 flat circle magnets also glued into place 10mm diameter and 2.5mm thick. I also placed a thin piece of foam on the bottom and a thicker piece on the top to hold the quad in place when closed
Print settings:
Printed on a QIDI Tech X1
Supports: No? Could be used for the hinges but didn't make a difference on my prints
Infill: I used 10% but would recommend higher as I ran into some issues with this