LED light bar arm for Artillery Genius
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Inspired by the LED light strip holder for its bigger brother by venegade, I decided to make a version for my…
- Rating
- 5 / 5
- Likes
- 43
- Downloads
- 223
- Makes
- 3
- Views
- 1,938
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Inspired by the LED light strip holder for its bigger brother by venegade, I decided to make a version for my Artillery3D Genius!
Because the Genius has an injected molded top bar and not a piece of extrusion, I needed a different mounting system. I decided to go with a clip arrangement—the arms just clip onto the top bar, and friction and spring tension keep them there. They end up holding quite firmly, but can easily be released by pushing the bottom of the clip away from the top bar.
I was super lucky, and thesejust clear the Z-link belt and the extruder gantry when at the max Z height, so no worries about accidental collisions.
The arms angle the light back towards the print bed about 10° off of perpendicular, and have cable retention clips integrated into the back channel for routing the power. They were designed for these light bars from Amazon, but because they just have a spot for an M3 nut at the end, should be easily adapted to anything else.
Print instructions
Category: 3D Printer Accessories Summary
Inspired by the LED light strip holder for its bigger brother by venegade, I decided to make a version for my Artillery3D Genius!
Because the Genius has an injected molded top bar and not a piece of extrusion, I needed a different mounting system. I decided to go with a clip arrangement—the arms just clip onto the top bar, and friction and spring tension keep them there. They end up holding quite firmly, but can easily be released by pushing the bottom of the clip away from the top bar.
I was super lucky, and thesejust clear the Z-link belt and the extruder gantry when at the max Z height, so no worries about accidental collisions.
The arms angle the light back towards the print bed about 10° off of perpendicular, and have cable retention clips integrated into the back channel for routing the power. They were designed for these light bars from Amazon, but because they just have a spot for an M3 nut at the end, should be easily adapted to anything else.
Print Settings
Printer:
Artillery3D Genius
Rafts:
No
</div>Supports:No
Resolution:
0.2mm
</div>Infill:15%
Filament: Duramic PETG black
Notes:
Two arms can be printed at once on the Genius; they just need to be angled at 60° and 240°.
You'll need to print these with a hefty brim to keep the ends from lifting.