D1mini Sensor Case - LD2410C, BH1750

Original project: https://www.printables.com/es/model/189821-d1mini-sensor-case-dht22-bh1750

I Modified the project to be able to store a LD2410C instead of the temp sensor.

Also i opened part of the top case for the light sensor, as the measurements were pretty low.

There is plenity of space for the cables, so you should be able to even make it shorter.

My cables are a bit too long but it works perfectly

The case it's for the ESP32 D1 Mini but if you remove the center square on the top, you can fit a Wemos ESP8266 in there.

This is the code on ESPHOME for the Wemos ESP8266 D1 Mini:

i2c:

sda: GPIO4

scl: GPIO5

scan: false

uart:

id: uarts

tx_pin: GPIO15

rx_pin: GPIO13

baud_rate: 256000

parity: NONE

stop_bits: 1

ld2410:

timeout: 30s

max_move_distance : 6m

max_still_distance: 0.75m

g0_move_threshold: 50

g0_still_threshold: 20

g1_move_threshold: 50

g1_still_threshold: 20

g2_move_threshold: 40

g2_still_threshold: 40

g3_move_threshold: 40

g3_still_threshold: 40

g4_move_threshold: 40

g4_still_threshold: 40

g5_move_threshold: 40

g5_still_threshold: 40

g6_move_threshold: 30

g6_still_threshold: 15

g7_move_threshold: 30

g7_still_threshold: 15

g8_move_threshold: 30

g8_still_threshold: 15

sensor:

• platform: ld2410

moving_distance:

name : Moving Distance

still_distance:

name: Still Distance

moving_energy:

name: Move Energy

still_energy:

name: Still Energy

detection_distance:

name: Detection Distance

• platform: bh1750

name: "BH1750 Illuminance"

address: 0x23

update_interval: 20s

binary_sensor:

• platform: ld2410

has_target:

name: Presence

has_moving_target:

name: Moving Target

has_still_target:

name: Still Target

Category: Other