Anycubic Kobra Proximity Sensor (Probe) Replacement bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a replacement mount for the Anycubic Kobra, not sure if this works with original cover but upgraded should be ok
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 67
- Makes
- 0
- Views
- 696
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Anycubic Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This was a simple part I did up during the process of repairing a Kobra that I ended up with, after updating the cooling I found that I didn't have a Proximity sensor anymore. In my case I ordered a LJ12A3-4-Z/AX from Ali and installed it. After verifying it worked with a Zip tie this was the result.
2x M3 x 8mm to mount into original plate. Adjustable up and down simply using nuts to hold into correct height. Printable upright or lying down, in my case I had the block down and just cleaned up the little stringing from the overhang. No support required that way.
I have done this in PLA+ but recommend PETG if PLA starts to deform although it shouldn't thanks to fan proximity. End of arm sits tight against Blower upgrade you can see.
**Update added STEP file so that this can be modified to suit other set ups.