Petlibro (dockstream) bowl clamp
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My cats tend to try to pull the bowl of the Petlibro waterfountain, which result in a wet floor. This design clamps it.
- Rating
- 5 / 5
- Likes
- 19
- Downloads
- 125
- Makes
- 1
- Views
- 1,070
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial
My cats tend to try to pull the bowl of the Petlibro waterfountain, which result in a wet floor. This design clamps it against a wall or furniture.
After 3D scanning the bowl itself i made it a negative resulting in 2 clamps to hold the waterbowl in 1 place near a wall or piece of furniture.
I did left room/a gap between the backside of the bowl itself and the end of the mount, so you can remove the bowl easily.
The notches are a bit roughly scanned at the lower part of the notch, but it will work.
Printing orientation: flat like how you would mount them, with the notches on the upper side. (as/is)