1 / 5
Papertowel, adhesive tape and spool holder "strongest shape" — image 1
1 / 5

Papertowel, adhesive tape and spool holder "strongest shape"

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Versatile big pole to fit circular stuff on there. Paper towels, adhesive tape, spools of wire or even filament!

Rating
0 / 5
Likes
2
Downloads
17
Makes
0
Views
230
Reviews
0

Updated at source:

Model information

Category
Organizers
License
Creative Commons — Attribution — Noncommercial — Share Alike

When I designed this, the intended usecase was for rolls of adhesive tape, but I quickly realized how versatile it is. Apart from the rails and the universal attachable hook, this is the part of my wall storage system that I have printed the most. I've printed five of them and I still could use more. Good thing that it prints quickly and easily. It is a very strong shape  ;) and will probably snap your rails before breaking itself. Like all of the parts of this system, it is designed to print easily and quickly, save material and still be able to take all the (ab-)use it is going to get in the workshop. Aesthetics are an afterthought, if any. My only gripe with this design is, that it can slide sideways, but fixing that will require additional parts, so far it hasn't been a problem. what do you think?

Recommended settings: print lying on the side. 0.6mm nozzle, 0.8mm extrusion width, 0.4mm layer height. 3 perimeters, infill is irrelevant, no supports. Keep your flowrate in check with the aforementioned settings, I use a chinese highflow nozzle and keep my head speeds at 55mm/s and below to prevent the extruder motor from skipping. 

I printed some with a brim, but if your adhesion is okay, you shouldn't need one.

On my Ender3 s1pro that takes 30 minutes and uses under 25g of plastic. PLA should be fine, unless your workshop gets very hot.