Tight Tolerance E3D Titan Direct Drive Outfeed
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Titan outfeed with tighter tolerances to the extruder drive wheel and idler bearing.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 11
- Makes
- 0
- Views
- 99
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
E3D Titan outfeed with tighter tolerances to the extruder drive wheel and idler bearing. I made it to improve feeding of flexible filament. There's a little bit less wiggle room for it to get sucked between the drive wheel and the edge of the tube.
I also added a hole sized for the same 2mm hex key used to remove the extruder cover - just hook the short end through it and pull it out - WAY easier than getting the stock one out.
Printed at .12 layer height. Ideally, it should be printed with a resin printer but we use what we have.
Like all of my files that interface with mating parts, should be sliced with Cura's Slicing Tolerance set to “Exclusive” (or equivalent in your slicer of choice) for best fit.
After printing, insert a piece of PTFE tubing and cut it off flush.