UMX Turbo Timber Prop Hub ( Long Shaft )
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replaces original part on the Turbo Timber but will probably fit many others.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 89
- Makes
- 0
- Views
- 286
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Manufacturer doesn't like to carry stock so this solves that problem.
I printed mine with PETG only because I had some laying around. I'm sure any other type of filament will work just fine. I used 100% infill and supports touching build plate only because of the hole for the small motor shaft that will need to have access. ( Note: You will not see the hole go all the way through. I did that just to show you what I was talking about. The infill was easily removed with a tiny jewellers flat head screwdriver. I also used a 1.65mm drill bit in a pin vice to enlarge all of the holes just a wee but so the screws would fit.
I tried to break one where the originals always break and couldn't easily do it so that's a bit of satisfaction.