Doggie Bag Dispenser (36 or 20 rolls)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I've seen other dog bag dispensers that hold like 5 rolls, but I have two german shepherds and I usually buy a box of…
- Rating
- 3 / 5
- Likes
- 22
- Downloads
- 114
- Makes
- 1
- Views
- 1,048
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Share Alike
I've seen other dog bag dispensers that hold like 5 rolls, but I have two german shepherds and I usually buy a box of 36. So I designed a holder that would actually fit a whole box worth.
For the 36 bag design you'll need to print this many:
(1) gsd-head
(2) floor
(1) front-lip
(1) front-top
(2) profile_left²
(2) profile_right²
(1) slide_back²
(5) slide_middle²
(2) stilt
(2) wedge-small
(3) wedge-large
(10) anglestop¹
¹These prevent the slides from going all the way to the bottom, you can just omit and glue if you want. I was planning on using them, but ended up just gluing.
²Several of the parts use modifier meshes to generate the hexagonal pattern, denoted by the suffix "_modifier" in the filenames.
For the german shepherd head I used thing:1685217 by quisalrod and printed in woodfill.
I don't know why I designed this with so many screws, but you need (24) M3x[4 or 5 or 6]mm and (2) M3x[8 or 10]mm. If I do a revision I'll delete most of these.
For anyone else designing something like this I made some measurements and came up with the following 95th percentile measurements in mm:
Diameter 65.08 stdev 0.94
Width 30.78 stdev 0.47
Greener Walker brand with cardboard roll inside.
A floor angle of 12° seemed to work well.
Overall I'm pretty happy with the look, but it doesn't dispense as smoothly as I'd hoped.
v2: Improved floor design slightly and repaired STL.
Print instructions
For the vertical frames you can print in anything, but any part that needs screws - which is everything else - should be PETG or else the M3 screws may destroy it.
I printed the front in Colorfabb Woodfill and only ended up using two screws, which was plenty.
I always do 3 perimeters. Printed with 0.6 nozzle for speed.