Helmet camera with your mobile phone - holder kit

This will hold your phone on to your helmet and you can make movies without a specialized camera. Works very well. It is solid enough, make it with 5 layer walls.

Two parts: one to attach to the helmet, where the phone holder will slide in, tightly (0.2mm gaps). There's a hole for a safety pin after mounted, if needed.

So far I have made versions for 5 mobile phone models:

• iPhone 11 - validated
• Redmi note 10 - validated
• SGalaxy A52
• SGalaxy A13 - validated
• Huawei P30 pro

Gaps are smaller than 1 mm all around the phone so it just slides in tightly and doesn't move or fall out. Nevertheless, there is a break/stop piece, if needed.

The holder frame has holes to access side buttons, power cord, jack, microphone, speaker, etc.

Screen is totally accessible and usable.

I'd like to have a generic version but meanwhile I will just make variations for different models upon request. There are differences between models in dimension, position of the buttons, etc. Please send a message.

The head piece is to mount on the helmet with the help of a couple of ties. Try out the position and the angle you get on the screen before making it tight.

If you have a screen protection you might have to force open the frame a little for it to slide in.

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3 Pro

Rafts:

No

Supports: 

Yes

Resolution:

rough is enough

Infill: 

20%

Filament: any pla worked well any

Notes:

Use five layer walls for making it stronger.
Print phone holder laying down, fewer support needed.

Print helmet piece with flat surface down for a good surface.

It might be hard to remove supports from inside the "tunnel" for a 3rd tie.

I print it with low quality settings (0.28mm) and takes roughly 6h to print.

Category: Mobile Phone