Bed Leg Extension Feet +10-30mm Z for EMODA 16 Inch Metal Bed Frame
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Extension Feet to raise bed frame additional 10, 20, or 30mm in height, +Tester.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 38
- Makes
- 0
- Views
- 250
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Get new raised bed frame. Buy storage bins to put under raised bed frame. Find out Storage Eyes (the bins) are bigger than Storage Space by about 5mm on the Z. *facepalm* That's ok, I have a Print for that!
10 minutes later in Blender (most of that used to remember all the shortcuts after not using Blender for 6mo), I have feet to add 10, 20, or 30mm on the Z, with an internal size of 21mm x 40.3mm, an additional sleeve height of 30~mm and a wall thickness of 8~mm.
These feet should fit the legs on the EMODA 16 Inch Metal Bed Frame, which are approximately 21mm x 40.3mm, and using the included Tester, I added a tolerance of +0.2~mm and I got a perfect fit with the Tester. Highly advised you double check the size of your bed frame legs with a caliper, then print the Tester to test fit.
My print settings: Tester with 2 walls, 10% lightning infill, 2 Bottom/Top layers; main Feet with 6 walls, Bottom Layers at 50 for a solid bottom in Orca, 40% gyroid on the sleeve section (another wall or two would probably be better than infill), 5 Top layers, printed in black ABS. PETG should work, as well. Print time on the X1C at Ludicrous, 9x 10mm Feet is approx 6hrs 33mins, 11hrs on Standard, but your mileage may vary.