1 / 3
Plant hold + hydrate
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A planter inspired by the unreleased work of PlayConveyor, that will let you water deep the soil while holding plant
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 43
- Makes
- 0
- Views
- 470
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Inspired by this Instagram Reel from PlayConveyor, I wanted to give it a try and design something similar because YES, my bigger plant are dry most of the time and I can only water the surface usually. Moreover:
- It looks WAY BETTER than my cut plastic bottle planted in the pot
- It also serve as a plant holder! Which is AMAZING !
Sizing
So the tank is pretty small right now because my plants aren't that big either.
| Tank | 16mm wide x 20mm deep |
| Water capacity | about 40ml |
| Height | 180mm height to bottom of the tank 200mm until top of tank |
Printing
15% infill in 0,20mm should be suffisent.
PLA is perfectly fine (I'm using Opal Green Prusament PLA)
The first version needed support (included), the second version doesn't.
Changelog
- v2: added gutter into tank, smaller hole
- v1 : original version.
Known issues: the water go through pretty quickly and left water can be spotted in the tank part.