Creality Ender 2 Pro

This is the dimensional model of Ender 2 Pro made by reverse engineering (manually measured) with some official parts from Ender 3.

WARNING! DUE TO MANUAL MEASURMENT THERE ARE SOME INACCURACIES. PLEASE, ALLOW AT LEAST 0.5 mm OF CLEARANCE. ALSO, REPORT ME IF YOU FOUND ANY ERROR.

Important notes:

• Parts were tested for parts mutual matchings and collisions and thus they are accurate to some extent, although I didn't print any parts (except https://www.printables.com/model/528496-beekoohaa-printhead-beta-for-creality-ender-2-pro-) to check physical matches and collisions.
• Due to complex geometry of the molded parts (and weird design) some of details like reinforcing ribs forming simple surface are omitted (actually they are converted to single block).
• Also, since I started to made this model after I cut my case, there are reinforcing ribs which has inaccurate size.
• Model doesn't have spool holder and tray.
• It also has very simplified screen and power supply.
• And also it doesn't have screws, nuts, washers, belts, tensioners, couplers and other generic mechanical parts, except those which affect modding (like screw on the Y carriage which touch the endstop switch and thus used for the carriage movement measurements).

Credits:

• Benas Griauzde for providing SD slot for the mainboard
• Citruzzzor_400822 for helping with measurements
• Bálint Leon Seregi for providing base model for the mainboard

P.S. If you want this model to be complete as possible - send me links to the models of the missing parts, and I will add them in the next version.