.410 Bore Shotshell Pack replicas and snap caps
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
.410 Bore Shotshell accurately sized replicas, separate brass head and case pieces, and snap cap/dummy rounds.
- Rating
- 0 / 5
- Likes
- 42
- Downloads
- 348
- Makes
- 1
- Views
- 996
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Share Alike
A .410 bore shotgun shell, also known as .410 shotshell, is a centerfire shotgun cartridge. Centerfire shotgun shells were designed in the mid 1800s.
Includes 2 lengths: 2 1/2in (most common, 2.5in, 60mm), and 3in (72mm).
Note: Shotgun shells are measured by the total length of the uncrimped/unfolded shell. The actual length of a loaded 2 1/2 inch shell is around 2.4in.
Print this for props, display, education, training, or just because it's cool.
Contains 9 files:
- Accurately sized replicas: 410Bore_2.5in_cartridge.stl, 410Bore_3in_cartridge.stl
- Separate brass head and case pieces for easily printing in different colors: 410Bore_2.5in_head.stl, 410Bore_2.5in_case.stl, 410Bore_3in_head.stl, 410Bore_3in_case.stl
- Snap cap/dummy rounds for cycle and dry fire practice, with firing pin hole and reduced case size: 410Bore_2.5in_snapcap.stl, 410Bore_3in_snapcap.stl
- Information txt file with recommended print settings: 410Bore_pack_info.txt
Originally uploaded on Thingiverse: https://www.thingiverse.com/thing:6139039
Print Settings:
- Material: Tested with PLA and PLA+/PLA Pro.
- Overall print size: 72mm tall (3in cartridge), 13.59mm diameter.
- Layer Height/Quality: 0.16mm or less recommended, 0.12mm works best.
- Infill: 10% is fine for display, 20% or more recommended for snap cap use.
- Print Speed: 50mm/s or less recommended. I do 40mm/s overall speed and 10mm/s initial layer speed.
- Adhesion: A brim might be needed, depending on the printer and bed type. I have a textured PEI bed, and with proper calibration, additional adhesion isn't needed.
- Post print: The pieces may require some sanding or filing for proper fitment if the bottom layers bulged out a little. Fitment should be a little snug, but easy to take in and out. A properly calibrated setup shouldn't need additional work.