Filament dryer heaterbox cradle for round heaterboxes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A cradle to support a round filament dryer at an angle, (for putting on the lid of a Lack V2, or similar enclosure).
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 14
- Makes
- 0
- Views
- 239
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
I recently covered my Lack V2 enclosure's lid with industrial-strength Velcro. Then, I snagged a few heaterboxes off of Amazon's Prime-day. Unfortunately, I didn't consider how little contact area there would be for Velcro.
This box is designed to be glued, (or Velcroed), to the top of an enclosure with a lift-able lid. I didn't bother with screw holes, because I was using self-adhesive Velcro. It will support a nearly-full spool, (I'm not cracking open a brand-new spool just to test this), at as wide as the lid is designed to be propped open on the support stick, and then some.
The print file is, frankly, overbuilt, with 40% gyroid infill where the model is thinnest, and 15% everywhere else. I printed it in PET, which is probably the lowest temperature filament you should print it out of, since it will get warm in direct contact with the heaterbox. It's designed for printing with an MMU2 in single-filament mode. I've included it, but I suspect you'll want to make changes.
The small end goes towards the front of the lid.