Remove Before Printing - Dust Cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
To test out ironing i created this simple "Remove before Printing" tag similar to a Remove before Flight found on many…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 28
- Makes
- 0
- Views
- 406
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
To test out ironing i created this simple "Remove before Printing" tag similar to a Remove before Flight found on many aircraft.
Once printed simply insert some spare 1.75mm filament in the hole. The hole is 1.60mm so it's a tight fit. I had success with using a pointed tip and some pliers to slowly and carefully work the filament into the hole then trimmed it to fit.
I used Red for the tag and white for the letters, printed in PLA.
Print instructions
Print Settings Below.
Resolution: 0.20mm Quality
Material: PLA
Filament Profile: Prusament PLA
Filament Brand: Spool 3D Red, Canadian Maker Series White
Ironing: Enabled all top layers
Detect Thin Walls: Enabled
Extra Perimeters: Enabled
Other: Added a colour change at 4.20mm for lettering.
Approximate print time: 90 Minutes
Printer: Prusa MK3S
Post printing
Cut a segement of 1.75 filament approximately 5-6" in length.
Cut a spear/point on one end.
CAREFULLY insert the pointed end into the printed part using pliers, until around 0.5-0.75" of it is inside or until snug.
Test fit the other end of the filament in the extruder.
Trim end until you get a desired print.
Remember to remove before your next print :)