1 / 1
Perpendicular LRS DIN Rail Mounts for Voron Printers
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Put that power supply the other way
- Rating
- 5 / 5
- Likes
- 51
- Downloads
- 294
- Makes
- 3
- Views
- 1,249
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- GNU General Public License v3.0
Here's a set of clips for mounting an LRS power supply perpendicular to the DIN rails in your Voron or similar printer. DIN rail spacing is at the Voron standard of 185mm edge to edge.
BOM
- 4x M4 x 6mm BHCS
Print List
- 2x DIN Clip A
- 2x DIN Clip B
Installation
TL;DR – Don't install all the clips onto the power supply and try to snap it down in one go. Do a side at a time.
- Using the M4 screws, install a pair of clips on one side of the power supply such that it can be clipped into one DIN rail, but don't clip it in yet
- Set the power supply down about where it would clip in, then use it as a guide to add the clips onto the other DIN rail.
- Clip in the side which has the clips screwed into the power supply
- Nudge the other clips (attached to the DIN rail but not the power supply) into place
- Install the M4 screws
There's some left/right wiggle room in the mounts if things don't perfectly line up.