1 / 1
Dig Octa + Meanwell 600 Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Print to mount a dig octa above a meanwell 600
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 138
- Makes
- 0
- Views
- 1,049
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
This is a simple mount for a QuinLED Dig Octa to screw into the sides of a meanwell 600 powersupply. Provides a little spacing between the bottom of the mount and the power supply to make sure heat isn't getting trapped.
The V2 model is hollowed out a bit to lower the amount of filament used BUT is a little less rigid. I left .5mm of material under the dig itself to prevent shorts.