1 / 3
Ducky the Lop Eared Bunny No Supports Needed, fixed, with ornament eyelet — image 1
1 / 3

Ducky the Lop Eared Bunny No Supports Needed, fixed, with ornament eyelet

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I wanted to make an ornament/pendant version of Ducky, but openscad couldn't work with the .stl file because it wasn't…

Rating
5 / 5
Likes
21
Downloads
124
Makes
4
Views
490
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

I wanted to make an ornament/pendant version of Ducky, but openscad couldn't work with the .stl file because it wasn't a 2-manifold. I eventually fixed it with meshlab but I unfortunately don't really know or understand the recipe I used to do so. Then I placed the eyelet over the center of gravity, so that it hangs right as a tree ornament.

Print instructions

Category: Sculptures Summary

I wanted to make an ornament/pendant version of Ducky, but openscad couldn't work with the .stl file because it wasn't a 2-manifold. I eventually fixed it with meshlab but I unfortunately don't really know or understand the recipe I used to do so. Then I placed the eyelet over the center of gravity, so that it hangs right as a tree ornament.

Notes:

Prints fine with no infill, 3 walls. With the natural/transparent PLA I used, 10% infill produced distracting patterns on the surface besides being unneeded.

In the cover photo, the left bunny is made using cura 2.3's "fuzzy skin" mode. "fuzzy skin" can be found under "experimental" and is not enabled by default.

Tags