1 / 4
Paddleboard Fin - SUP Fin
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mid/Small size fully-printable paddleboard fin for US-Box attchment system.
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 217
- Makes
- 1
- Views
- 1,845
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
Paddleboard (sup) fin. Designed as a spare fin in case of forgetting original fin at home. Compatible with US-Box attachment system secured by screw or by quick-click rubber pin.
- Recommended print from PETG with 100% infill / note that infill 25% were tested, but it absorbed water inside by tiny holes.
- Good print results with a 0.4mm nozzle and 0.2mm layer height
- Estimated print time around 10 hours and 150g fillament used for 100% infill
The fin was tested on my 11.6ft (3.5m) Touring paddleboard with good results on a calm lake. It does not stabilize board as much as original one but it was significantlly better than nothing used. This fin is about 2inch / 5cm smaller than original one because of my maximum printable area of my Prusa MINI printer.