1 / 2
Concrete Slump Cone
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fill with concrete, then lift cone and measure slump
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 105
- Makes
- 0
- Views
- 751
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print out of ASA for UV resistance as this will most likely be used outside. Other rigid filaments such as PETG, ABS, PLA etc might also be acceptable. Avoid TPE or TPU that will flex too much.
If your printer isn't tall enough, cut into two parts with mating connectors in your slicer. After printing both parts, use heavy duty tape on outside, glue inside joint.
Finally sand any rough edges on inside before using.
See https://en.wikipedia.org/wiki/Concrete_slump_test
Editable model is available for free in onshape