1 / 2
Power Strip Holder for HP Z24n G2 Monitor Stand — image 1
1 / 2

Power Strip Holder for HP Z24n G2 Monitor Stand

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Need to hold a power strip to the back of your HPZ24n G2 monitor stand? Maybe this will work for you!

Rating
0 / 5
Likes
0
Downloads
12
Makes
0
Views
345
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution

The power strip that I have has two pairs of slotted mounting holes in it that are 32-mm on center. The mounting holes are 7-mm in diameter and the slots are 3-mm in diameter.

Material, fill, and layer height are flexible. The assembled version shown is Hatchbox Black ABS at 0.2-mm layer height and 20% fill. Support is recommended.

Hardware - Uses M3 3-mm X 5-mm heat-set nut. Short screws are M3X5-mm flat-head. Long screws are M3X10-mm flat-head

The rectangle takes two of the M3 heat-set nuts and two of the M3X5-mm screws

The clamp strip takes two of the M3 heat-set nuts and two of the M3X5-mm screws

The clamp legs each take one of the M3 heat-set nuts 

The M3X10-mm screws hold the legs to the clamp strip.

The rectangle is meant to sit on top of the monitor of the stand. The legs are meant to clamp to the lower end of the stand and not get in the way of the raise and lower capability of the stand.

I found that just the top part was sufficient to hold up my power strip with most of the plugs populated. I tested the clamping feature of the clamp strip and legs and it appears to work correctly.

Monitor image is shown for reference for what the stand looks like, the parts are not attached 

 

Tags