Vase Mode Desiccant Box

I'm finally moving away from gallon ziplock bags and storing my filament in 20qt Sterlite gasket boxes.  I needed a bunch of (at least a dozen) desiccant boxes, and while there's tons of models out there, they're not exactly efficient to print.  Most larger boxes were computing at 2+ hours to print, even on an X1C.  Unacceptable!

So I designed this desiccant box from scratch in tinkercad.  You can print both the box and lid in less than 45min on a decently quick printer, using only 24g of filament.  Acceptable!

Print both parts as provided in vase mode (duh).  I recommend 0.6mm line width and at least 3 bottom layers.  If you go much above 0.6 on the line width (like if you're using a bigger nozzle), you will probably have to scale up the lid by a percent or two or it will be too tight a fit.