Lack Enclosure Power Cable Pass-Through (to fit XT60 connectors)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A cable pass-through for the Lack enclosure that will fit XT60 connectors after PSU cable modification
- Rating
- 4 / 5
- Likes
- 7
- Downloads
- 59
- Makes
- 2
- Views
- 392
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
If you make this model and like it, please post your make and rate the model, that would make my day!
I'm currently building a Lack enclosure and realised that any time I want to pull the printer out of the enclosure, for maintenance or whatever, I will have to disconnect all the cables from the externally mounted PSU. Which would be very annoying!
So I cut the 2 power cables and added XT60 connectors, and cut the power panic cable and added a JST connector. With this upgrade it meant that the standard power cable pass-through models for the project wouldn't be large enough for the XT60 connectors. And I wanted to keep the hole as small as possible so I designed this.
It's a snug fit but it does fit. If your prints run small or something maybe scale it up by 3.5%.
I used a 20mm spade drill bit on the table (if you had a 20mm standard bit that would be much better I imagine), and I masked both sides of the table with painters tape to prevent chipping.
This was my first time designing anything with a thread and I'm really happy with how it turned out.
Model dimensions:
- Inside Diameter: 16.5mm
- Outside diameter: 19.6mm
- Tube length 50.3mm
I printed these on an MK3S+ using the following settings:
- 0.15mm detail with a 0.6mm nozzle (of course 0.4mm nozzle will be fine)
- 15% infill
- 3 perimeters
- Aligned seams