Feather Box with top for TSL2591
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.35 – €1.65 net (excluding VAT)
For file: top (sensor)_0.4n_0.2mm_PETG_MK4_1h31m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.50 excluding VAT (range midpoint).
- Weight reported by the author
- 20 g
- Print time reported by the author
- 1.51 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Modified Feather enclosure top to hold a TSL2591.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 27
- Makes
- 0
- Views
- 294
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I modified the box top to handle a TSL2591 sensor from Adafruit. The holes are made for M2 screws and nuts. I used M2x6 but it looks like shorter ones could be used too. The hole is sort of a hack because its made wide enough to not impact any components but without any standoffs to avoid shadowing the light sensor. I'd recommend breaking the LED jumper on the back to avoid light pollution and any possibility of heat buildup near the case.
I edited the user parameters in f360 to have tighter box notch tolerances. The f3z is attached so you can change hole size if you need to. The sketch is there so it should be easy to modify as needed.
I printed this in PETG on a MK4 with a 0.4 nozzle without any special slicer settings and the box fit snugly.
This sort of device could be used with lunar.fyi and esphome as described here: https://lunar.fyi/sensor
Be careful of the GPIO pin settings in Lunar, the various boards have different pinouts to the i2c bus, unfortunately.
This model is based on the “Adafruit Feather Box Enclosure”.