Sovol SV06/Plus Resonance Compensation Ringing Tower

*Note this 3mf file should be printed with SuperSlicer!

This model contains all settings and parameters suggested by Klipper official docs.

• Suggested layer height is 0.2 or 0.25 mm.
• Infill and top layers can be set to 0.
• Use 1-2 perimeters, or even better the smooth vase mode with 1-2 mm base.
• Use sufficiently high speed, around 80-100 mm/sec, for external perimeters.
• Make sure that the minimum layer time is at most 3 seconds.
• Make sure any "dynamic acceleration control" is disabled in the slicer.

All other requirements found under the Ringing frequency section have been adjusted as well in the start_gcode section.

Should work with any printer though you might have to adjust the placement of the model depending on your build plate. Warning, I have only tested this with my SV06.

Print settings:

• Print with PLA that has an extrusion multiplier of 1 (shouldn't matter much if +/- 0.02).
• Print using SuperSlicer.
• As long as you follow the previous 2 points, you do not need to adjust anything else. Just open in SuperSlicer and print!

My Sovol3d related repositories:

• OSS Klipper Configuration
• Everything Sovol SV06