Multimeter Holder / Wall Bracket for Duratool D03041
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holds D03041 multimeter and at least two sets of probes / leads
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 25
- Makes
- 0
- Views
- 266
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Holds D03041 multimeter and at least two sets of probes / leads
Print Settings
Printer Brand:
Creality
Printer:
CR-20
Rafts:
Yes
Supports:
Yes
Resolution:
200
Infill:
38
Filament: ASA
Notes:
This large print took well over 24H on the CR20 using fairly conservative speeds.
Even with raft, the ASA material warped and split a little at the corners. However these defects appeared minor on the finished item, and the central compartment for the multimeter turned out undistorted.
The item was designed to be printed at a 30 degree angle and using tree supports.
If using ASA then would recommend to use large rafts as possible, and strong contacts between raft and bed; raft and component. Enclosed printing area, fan off.
FreeCAD source model included
Category: Electronics