1 / 3
OOni Koda 12, gas control knob with adjustment dial — image 1
1 / 3

OOni Koda 12, gas control knob with adjustment dial

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is printed knob with adjustment dial, is serves to remember wanted flame strength.

Rating
0 / 5
Likes
8
Downloads
66
Makes
0
Views
1,098
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

This is used to remember set flame. I use it when i want to heat up the oven between pizzas, and then when i want to cook them, to set it easily to low flame without looking in the oven and being precise. You just find low flame once when oven is lit, tighten the wing nut and you have it ready :)

There are 2 version of the file. 

  1. With printed bolt on knob.
  2. With M8 hex bolt insert (13 mm between sides) (recommended) 

 

For each version you will need M8 wing nut, and M5 bolt (60mm) and m5 nut. 

I inserted the M5 bolt from the underside (there is premade hole in the oven to get access) in a hole next to the dial (also premade). So no drilling or modding is necessary. Then put m5 nut from outside, tighten and use some glue for nut not to get loose. 

And for m8 bolt insert version you will need m8x30 hex bolt. If fit is not tight enough, you can glue it in place.

I recommend printing with petg, abs or asa because of the radiating heat from the oven. 

Tags