1 / 3
Netzteil 350 Watt für MK3s(+) bzw. MK4 — image 1
1 / 3

Netzteil 350 Watt für MK3s(+) bzw. MK4

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Ich habe, da ich meinen Raspberry zum steuern dran haben wollte und meine MMU2s ja auch noch dran hängt.

Rating
0 / 5
Likes
0
Downloads
12
Makes
0
Views
200
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Deutsch

Ich habe meine Prusas mit dem stärkeren Netzteil (350 Watt) nachgerüstet. Diese habe ich hier gefunden: https://de.aliexpress.com/i/32977457443.html

Grundsätzlich läßt es sich gegen das Orginal Netzteil austauschen, aber…. :

Zum einen sind die Kabelabgänge nur seitlich raus, was aber eine ungünstige und unnötige Kabelverkürzung darstellt!

Zum anderen erinner ich mich dunkel (schon ne Weile her, daß ich Sie nachgerüstet habe…), daß das Kabel für Stromausfalldetektion, richtig übel war. 

Zu guter Letzt mußten die Kabel durch die verbaute Blende durchgeführt werden - nicht sehr komfortabel und bei dem Kabel für Stromausfalldetektion ging es so ohne weiteres gar nicht…

Diese Blende ist, von den Chinesen, 3D Gedruckt. Ich habe das ganze ausgemessen und ein 3-teiliges, auf den 3D Druck optimiertes Gehäuse designed. Es sollte ohne Support druckbar sein, greift auf die Orginalschrauben, des China-Netzteils, zu und benötigt nur noch ein paar M3 Ruthex Gewindehülsen, die man per Lötkolben leicht einschmelzen kann. 

Man kann ABS verwenden, aber für die Vorderseite mit der Schalter und Netzsteckeraussparung, habe ich aus PP gedruckt. Warum? Wenn man irgendwo etwa hängenbleibt, Platzt ABS sofort. PP ist, diesbezüglich, komplett unproblematisch…!

 

English

 

I upgraded my Prusas with the more powerful power supply (350 watts). I found this one here: https://de.aliexpress.com/i/32977457443.html

Basically it can be exchanged against the Orginal power supply, but.... :

On the one hand, the cable outlets are only out to the side, but this is an unfavorable and unnecessary cable shortening!

On the other hand I remember darkly (already ne while ago that I have retrofitted you ...) that the cable for power failure detection, was really bad.

Last but not least, the cables had to be fed through the installed panel - not very comfortable and with the cable for power failure detection it didn't work at all...

This panel is 3D printed by the Chinese. I measured the whole thing and designed a 3-part housing optimized for 3D printing. It should be printable without support, accesses the original screws, the China power supply, and needs only a few M3 Ruthex threaded sleeves, which can be easily melted by soldering iron.

You can use ABS, but for the front with the switch and power plug cutout, I printed from PP. Why? If you get stuck somewhere, ABS bursts immediately. PP is, in this respect, completely unproblematic ...!