quick release camera mount base, which can be attached to 1/4 inch photo screw
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I had an existing quick release mount from my normal camera tripod.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 156
- Makes
- 0
- Views
- 1,337
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Public Domain
I had an existing quick release mount from my normal camera tripod. But i needed a quick release base on my small desk tripod for usage of a dslr as webcam.
With the print i can attache the existing camera mount (ground is round about 4.4cm x 4.4cm) plate on the quick release which is screwed on the 1/4 inch photo screw of the small, desk tripod.
The system do not use any screws on its own. You can print free of support.
Attention: Once the hinge is closed, it should hold the mount tight enough to prevent the camera from wobbling. Test the system for stability before attaching a camera on your own.
Print instructions
- 0.2mm layer height
- 0.4 or 0.6mm nozzle
- no support
- 15% infill
Assembly
- place the printed plate on a desk and screw the photo tripot in the hole for the photo screw (on first assembly this should be a little harder).
- add the hinge inside the large hole
- !test if it hold tight enough to hold you camera!