1 / 2
Wing Mount Braces for Flite Test Legacy V2
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I made these to use some 6mm carbon tubes instead of the flimsy skewers that the kit comes with.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 19
- Makes
- 0
- Views
- 124
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
Print a pair of these (they fit diagonal on an Ender bed) and get some 6mm OD carbon tubes from Amazon. I used the carbon tubes to enlarge the original front hole. The rear is a little farther back than the original location but not by much. Hot glue these onto the inside of the fuselage and also hot glue the carbon tubes to these and the fuselage.
Much stronger than the bbq skewers. They work fine in PLA, might be better in PETG for the resilience.