Speaker Stand for Monitor Speakers (here: PreSonus Eris E3.5)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Most speakers are designed to sit flat on the tabletop; sound is not directed towards the ears. This stand helps :-)
- Rating
- 5 / 5
- Likes
- 50
- Downloads
- 270
- Makes
- 5
- Views
- 2,705
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Share Alike
Speaker Stand for Monitor Speakers
The Problem: if Monitor Speakers sit flat on a tabletop, the sound is not directed towards the ears.
My Solution: incline the speakers upwards so that they are pointing straight towards the head of the listener.

The speaker stands shown here are designed for my PreSonus Eris E3.5 Multimedia 2-way studio monitors (shout-out to the Grumpy Old Geeks Podcast for this recommendation 😁)
If you use other speakers: my speakers are held at an angle of 20 degrees, the top surface that supports the speakers is 140 mm long. And yes, I went through a few iterations until I found the “right” angle :-)
Printing
Nothing particular here, I used black PLA.
Note that the STL file shows a solid block. To get a visible infill pattern, follow the usual hints:
- Set both Bottom solid layers and Top solid layers to 0 so that the infill becomes visible.
- Select a suitable Fill density and Fill pattern. I have used around 10% and “Honeycomb”.
- Select your preferred layer height. 0.3 mm works fine.
- Slice and print :-)

Installation
Using the remainders of the soft rubber pads that came with the speakers, I simply cut some more “pads” and attached these to the speaker stands:
