Prusa MK3s+ fan Shroud for mosquito hotend with silicone sock
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is basically a fun shroud/duct for the Slice Engineering's Mosquito Hotend with the Slice Engineering silicone sock
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 53
- Makes
- 0
- Views
- 700
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
In my setup, I am using the <Prusa I3 Mk3S+ Mosquito Hotend Upgrade> for the extruder mount.
Link: https://www.printables.com/model/49947-prusa-i3-mk3s-mosquito-hotend-upgrade
*** this mount works great, however i found out that the Slice Engineering's Silicone Sock doesn't leave room for the fan shroud thus as a result the fan duct on the left side start to melt.
So i made this to fix the issue
*Update 19/12/2023 : I switched from PETG to ASA because i put the printer inside an enclosure and wanted to be sure it will not melt due to high temperatures. However if your printer is not inside an enclosure the Fan Shroud will be just fine with PETG
Tools you will need:
1X M3 T-Nut
1X stock m3 screw that comes with the printers cooling fan
1X M3hex nut
1X M3X12mm screw
Print Settings:(PETG)
Infill: 25% rect
Perimeter: 3
resolution: 0.15mm layer height
fan settings

Print Settings:(ASA)
Infill: 25-30% rect
Perimeter: 3
resolution: 0.15mm layer height
Stock fan settings