cablemount1
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
5th attempt at a cable mount.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 23
- Makes
- 0
- Views
- 160
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
5th attempt at a cable mount. (drawn in sketchup, cleaned with netfabb) I had problems with the clip being too brittle and tried to fix it by fattening the clip. Didn't work? Maybe I need to change some slic3r setting?
This is supposed to hold the '3/8" Flex Tubing' cable sleeve I got from Home Depot (part# FLX-3810T). The bottom foot should mount on the ord-bot hadron x carrage using the 2 holes on the upper right side of the carriage plate.
Print instructions
Category: 3D Printers Summary
5th attempt at a cable mount. (drawn in sketchup, cleaned with netfabb) I had problems with the clip being too brittle and tried to fix it by fattening the clip. Didn't work? Maybe I need to change some slic3r setting?
This is supposed to hold the '3/8" Flex Tubing' cable sleeve I got from Home Depot (part# FLX-3810T). The bottom foot should mount on the ord-bot hadron x carrage using the 2 holes on the upper right side of the carriage plate.
Instructions
I finally got #5 to print as a usable part. Previous prints were too brittle. I used 1.75mm white ABS (measured 1.60-1.63) and set slic3r to use 120% extrusion. (Previous parts had linear voids at fracture points.)
Tested this against the Tubing Sleeve and it is a tight fit. Once I mount it on the printer I'll post a picture showing the fit.