Stand to hold a 10Kg roll of heat/vacuum-seal bag material and/or spools of wire
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A sturdy stand made from 3d printed parts, 1/2" electrical conduit, 1/4" all-thread and some hardware.
- Rating
- 0 / 5
- Likes
- 28
- Downloads
- 55
- Makes
- 0
- Views
- 571
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
This Stand was designed (with Alibre 3D Professional) originally to hold a 10 kG (22 lb) roll of heat seal plastic bag material. It's a big, heavy roll so I knew the Stand would have to be robust. The triangular end supports and all the filler pieces were printed on a Prusa Mk3+ out of Prusament PLA Galaxy Purple and Pineapple Yellow.
To keep the main conduit support centered on the all-thread, I printed 2 Conduit Fillers that slip into the ends of the conduit. To keep the Conduit Fillers in place they are printed with a groove around their mid point. Place a Conduit Filler next to a piece of conduit. With the Conduit Filler flush with the end of the conduit, mark the location of the groove on the conduit. Slip the Conduit Filler into the conduit (flush with the end of the conduit) and, using a center punch, punch or stake 4 or 5 places around the perimeter of the conduit to capture the Conduit Filler.
The length of the conduit depends on what you are trying to hold. For my bag holder, all three pieces of conduit are 14.25" (361mm) long. The two lower pieces of all-thread are 15.50" (394mm) long. The upper all-thread is cut 16.12" (410mm) long to accommodate the 5-lobe plastic knobs.
Also, the outside diameters of the flanged adapters will depend on what your are supporting. As you can see in the photos, spools of wire require no adapters.
I'm not sure what the diameter tolerance is for electrical conduit. The fit between the conduit and my printed parts was very tight. So, I cheated, threw the conduit on a lathe and turned down the OD until they fit. Ideally, if I was going to make more, I would increase the size of the openings on the printed pieces. I have not modified the attached files to increase clearance for the conduit. So, some hand fitting may be required.