F**K to Give Coin Equal Top/Bottom (Resized)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Resized to 50% and 75% while preserving top/bottom layers
- Rating
- 0 / 5
- Likes
- 29
- Downloads
- 403
- Makes
- 0
- Views
- 1,031
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Share Alike
When scaling this coin, X and Y dimensions scaled fine, but Z shrank the detail in the top and bottom layers. If I just scaled X and Y, the coin seemed too thick.
So I edited the model in blender to shrink the middle/non-detail section while preserving the top/bottom detail.
(Below assumes .4mm nozzle and .2mm layer height)
Original
Total Layers: 22
First Filament Change: between layer 3 and 4
Second Filament Change: between layer 19 and 20
75% scale
Total Layers: 17
First Filament Change: between layer 3 and 4
Second Filament Change: between layer 13 and 14
50% scale
Total Layers: 11
First Filament Change: between layer 3 and 4
Second Filament Change: between layer 8 and 9