DJI Mini 3 / 4 Pro cooler duct
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The Mini 3 Pro has no fan and so can overheat when used as a ground gimbal camera or when updating its firmware.
- Rating
- 4.667 / 5
- Likes
- 55
- Downloads
- 292
- Makes
- 3
- Views
- 3,088
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
I tried some of the other coolers available on Printables and the other place but none really felt like they did the job properly.
I have access to a 3d scanner and so I took a scan of the Mini 3 Pro in the closed position and then made a duct system that fits perfectly over the air vents and clips to the arms.
You will need an 80mm fan and 4 M3 bolts to mount the fan to the duct.
Prints with no supports if oriented upside down.
[edit]
I just received my Mini 4 Pro and the duct fits this craft too. The seal isn't quite as good but it's close enough to not really require modification.