Single-Width Modular 006/007 Shelves
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.85 – €3.49 net (excluding VAT)
For file: Modular__006___Halfsize_0.4n_0.2mm_PLA_MINI_03h15m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.17 excluding VAT (range midpoint).
- Weight reported by the author
- 38 g
- Print time reported by the author
- 3.25 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Single-width versions of the Modular Shelving System 006/007 unit-top shelves, w/ and w/o divider slot for 007
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 63
- Makes
- 1
- Views
- 318
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to throw a shelf on top of my new Modular 004 unit, but the only original ones were double its width, so I took the Modular 006 and 007 shelves and cut them down to the correct size. For the 007 shelf, I also made versions with and without a center divider slot. (If you want other divisions for the 007, just ask—but dividing it in the center already makes pretty small compartments.)
- 006__Halfsize: Modular 006 shelf resized to fit one single-width Modular unit (001, 002, 003, 004) or half a double-width one (005, 008)
- 007__Halfsize: Modular 007 shelf resized to fit one single-width Modular unit or half a double-width one, with no divider slot
- 007__Halfsize-Divider: Same as above, but with a single divider slot in the center
To attach this shelf to the top of another Modular unit, you'll need to print 2 pegs, several versions of which can be found in the original design and its other remixes. (For what it's worth, I couldn't get the original pegs to work and used the “0,2mm” pegs from “Beter Pegs” instead, with a tiny bit of poster putty in the deepest part of each channel to help them stay in place.) The optional divider to slot into 007 is also available to print from the original design.
You may noticed in the photos that I've also created a hook that works both with these shelves and with the original ones, so follow the link or check the original design's other remixes or my profile if you're interested.
No supports or brim should be needed if printing in the supplied orientations (on its back for 006; on its base for 007). Printing 007 on its back may give you better peg channels, but at that point you would need to add support for its front lip.