Apple Watch Charging Stand

This is a remake of my low-poly Apple Watch charging stand, with a larger diameter and obviously not low-poly. I think this looks much better. 

For the best finish make sure your seams are aligned to the rear of the model, otherwise using aligned seams, and not checking where they're aligned to can result in ugly bumps on the face of it. 

The charger is a tight fit by design, which makes it difficult to get out once you put it in – I've had mine in and out multiple times and I just use a pair or needle nose pliers to push the back of it from inside the model. I'm also just using a cheap $5 charger from aliexpress so I don't care if the back of it gets scratched by pliers, though you could probably use something hard and plastic instead of pliers.

I printed this in PLA+ on an MK3S+ using the following settings:

• 0.15mm detail with a 0.6mm nozzle (0.4mm is fine)
• 5% infill
• 2 perimeters
• Rear seams
• Organic supports

I've included print files for 0.4mm and 0.6mm nozzles at 0.15mm & 0.20mm layer heights