Hook for Modular Shelving System 006/007 Shelves
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A hook that fits on the edge of Modular 006 and Modular 007 (including the remixed half-width versions)
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 28
- Makes
- 1
- Views
- 227
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
This is a simple hook that clips over the edge of any Modular 006 or Modular 007 shelf wall, whether the unit is an original double-width version or one of my remixed single-width ones. The back is angled 8 degrees inward to allow the hook to grip the wall securely while still being added, moved, and removed with ease. I haven't tested the weight limits, so use your best judgment about what it can support. (Personally, I just wanted something to hold a screw-sorting card, and it'll presumably hold that up until the PLA naturally decomposes.)
No supports are required when printed in the supplied orientation (on its side), which I also recommend for strength. I didn't need a brim on my Prusa Mini+, but your printer may vary. (If you're not sure, I strongly recommend trying it without the brim first; if it doesn't work, it's not like it wasted more than three minutes and a sneeze of filament. But in the multiple versions I printed while designing, not one of them had trouble adhering to the plate.)